Here is another model of precast 3D printed forms for buildings. This is an ongoing project, I have made incremental steps and improvements over the last few years.
I anticipate the full size of these to be printed either in an on site printer or in an offsite printer. The model looks a little more like light frame spacing intervals, it might be spread out to take advantage of concrete span potential. Or it might stay at the compact spacing for extra strength.
Assembly requires three stages, diagrammed below: 1) print, 2) lift, 3) place.
LIFT
PLACE
Here are links to previous efforts I have made along the same lines. Whereas this post is more about the tilt-up walls, these previous ones were mainly about roof, ceiling, or floor slabs.
drdrr.work 